Wireless controlled lightdimmer by PIC12F629

The meaning from this design is to build it in -i.e. a shaded lamp- and to switch this lamp on and off the normal way, just like it was switched before the dimmer was build in, then you could by exception dimming the lamp more or less with your TV remote control. When you switch the power on there will follow a soft-start till the lamp burns at the previously adjusted dim level. With the ‘0′ button in TV mode you can dim the lamp, turn more and less bright. The remote control should send more then one RC5-signal per button-press seeing that the first one is ignored, this does imply that when the remote button is pressed a short time, there nothing happens. With the P+ and P- button from a system at choice you can adjust the maximum and minimum dim-levels and with the ‘1′ button the start-up brightness

Read More Source:
http://www.picbasic.nl/lichtdimmer_uk.htm
Thank you.

Power Supply   Switching Power Supply   DC to DC Converter   Inverter
Battery charger   Led flasher   Motor speed controller   LM317   IC 741
RF radiofrequency   Electronic control   Digital Circuit   Alarm home system
DC to DC converter step up voltage   Mini project   Temperature control
FM receiver   Dual power supply   Fluorescent lamp   Pic microcontroller
Led display   RF amplifier   FM transmitter   LM324   LM723   TL494
2N3055   LM338   SG3525   Li-ion battery charger   Pulse generator

Circuit Project Electronic

Wireless controlled lightdimmer by PIC12F629