Tri-Waveform Generator (Easy Oscillator Generator)

The Tri-Waveform Generator can be used for a number of different uses. The one that I use it for is a signal generator to test circuits. The frequency range is 20 to 20khz. and can be adjusted by R1. The duty cycle or the time that the waveform is high and the time that the waveform is low can be adjusted by R4. The purpose of R2 and R3 are to clean up any distortion on the sine wave output. To do this you must hook up the sine wave output to and oscilloscope and adjust R2 & R3 to make the sine wave as accurate as possible.

from ::http://home.maine.rr.com/randylinscott/may99.htm

Power Supply   Switching Power Supply   DC to DC Converter   Inverter
Battery charger   Led flasher   Motor speed controller   LM317   IC 741
RF radiofrequency   Electronic control   Digital Circuit   Alarm home system
DC to DC converter step up voltage   Mini project   Temperature control
FM receiver   Dual power supply   Fluorescent lamp   Pic microcontroller
Led display   RF amplifier   FM transmitter   LM324   LM723   TL494
2N3055   LM338   SG3525   Li-ion battery charger   Pulse generator

Circuit Project Electronic

Tri-Waveform Generator (Easy Oscillator Generator)