Circuit Project Electronic

The circuit presented on this page attemps to be an interface to convert pulses such as provided by a Basic Stamp or R/C receiver to a dual PWM(Pulse Width Modulation) signal required by an H-bridge. The simplest circuit would use a small microcontroller like a PIC. This circuit takes a more traditional approach. Many experimenters [...]

System designers must consider the timing and voltage differences between core and I/O power supplies (in other words, power-supply sequencing) during power-up and power-down. The possibility of a latch-up failure or excessive current draw exists when power-supply sequencing does not occur properly. The trigger for latch-up may occur if power supplies apply different potentials to [...]

This control circuit is suitable for the accurate control of DC motors, lighting levels, small heaters as well as other applications. The circuit converts a DC voltage into a series of pulses, such that the pulse duration is directly proportional to the value of the DC voltage. This circuit can operate with 8-35VDC and control [...]