single digit voltmeter by IC 4028 LM311

Advertisements

First bear it in mind that it is a single digit voltmeter which is 0-9 counts only on the positive side, that is it can measure +0 to +9V DC +/- 1V error. That may not be practical for the cost of the components above. It may be used as a toy logic probe. The reason for the circuit is not for usage, but to give design ideas. The methodology used is Gut Feel - Thumb Rule method.

First i explain the simple part, D1 a seven segment common cathode LED display is chosen as CD4511 is a sourcing driver. 4511 can be latched so it has been used here, it decodes binary 4 bit decade info to seven segment output. The four bits are derived from CD4029 up-down clock pulse counter. LM311 is a analog comparator with single supply capability which is the A-D interface.

To avoid resistors for each of the LEDs the LEDs are turned ON-OFF at 10KHz 50% duty cycle. The Nand Schmitt Trigger CD4093 is used as in IC4D as a 10KHz Clock which drives T1 transistor with a resistor R5. On turn on IC4D one input is high which is pin 12 pulled up to +5 and another Pin 13 is Low as C4 is in discharged condition in NAND gate both inputs high, gives a low output, the other combinations the output is high. So the output goes high, this starts charging the cap C4 which soon makes both inputs high, which in turn makes output low starting the discharge of C4. This is now evidently a endless loop, hence it is a oscillator. R*C = T …. 0.01uF * 10K = 100uS or 10KHz as F=1/T approx or better still multiply by 1.1 ?. I am not good at formulae but i manage with a calculator.

The supply and ground pins of CMOS chips have not been shown, see datasheet or earlier circuits.

IC4A is also a oscillator but slower which is good enough, it is slow so that a measurement can be made nearly every second. The IC4A slow clock is read by 4029 which produces a count-down binary nibble at Q1….Q4, This is converted to crude analog with R1…R4. The voltage generated is compared with the voltage you are measuring by LM311 which generates a Latch pulse to 4511 to freeze the reading where both voltages match.

Read more Source:
http://schematics.blogspot.com/2005/08/single-digit-voltmeter.html
Thank you.

This entry was posted on Wednesday, December 12th, 2007 at 8:54 pm and is filed under Digital, Lighting, meter. You can follow any responses to this entry through the RSS 2.0 feed.