Power Amplifier 45W with HEXFET IRF9540,IRF540

A ideal solution for the make a good, low cost power amplifier. It�s a ideal solution for the creation a system of home cinema. The preamplifier and the driver support in a operational amplifier [IC1]. The voltage fall in resistors R5 and TR2/R6, drive the output FET’s gates and is proportional with the input signal level. Transistors Q1-2 function as voltage stabilizers in the supply lines, but ensure also the essential voltage fall, because the IC1 it should not they are supplied with voltage bigger ± 18V. …

Part List

R1=47Kohm C1-2-6-7=100nF 100V MKT Q5-6=IRF9540
R2-12=1Kohm C3-4=22uF 25V Q7-8=IRF540
R3-4=3.3Kohm C5=220pF styroflex TR1=5Kohm trimmer multiturn
R5=1.2Kohm C8-9=4700uF 63V TR2=1Kohm trimmer multiturn
R6=[1.2Kohm] 820ohm *See text C10=1uF 100V MKT F1-2=fuse 3A
R7=270ohm D1-2=15V 0.5W zener J1=2pin connector 2.54mm step
R8=220ohm IC1=LF411orAD711or LF351 J2=5pin connector 5mm step
R9=27Kohm Q1=BC550C
R10-11=22Kohm Q2=BC560C All Resistors 1/4W 1% metal film
R13-14-15-16=150ohm Q3-4=BC547B

Read More Source:
http://users.otenet.gr/~athsam
Thank you.

This entry was posted on Thursday, September 6th, 2007 at 8:45 pm and is filed under Power Amp MOSFET. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.