LED VU Meter by LM339

The circuit below uses two quad voltage comparators (LM339) to illuminate a series of 8 LEDs indicating volume level. Each of the 8 comparators is biased at increasing voltages set by the voltage divider so that the lower right LED comes on first when the input is about 400 millivolts or about 22 milliwatts peak in an 8 ohm system. The divider voltages are set so that each LED represents about twice the power level as the one before so the scale extends from 22 milliwatts to about 2.5 watts when all LEDs are lit.
Buy VU Meter
The sensitivity can be decreased with the input control to read higher levels. I have not built or tested this circuit, so please let me know if you have problems getting it working. The power levels should be as follows:

1 LED = 22mW
2 LEDs = 42mW
3 LEDs = 90mW
4 LEDs = 175mW
5 LEDs = 320mW
6 LEDs = 650mW
7 LEDs = 1.2 Watts
8 LEDs = 2.5 watts

Source : http://ourworld.compuserve.com/homepages/
Bill_Bowden/page11.htm#oscilate.gif

Power Supply   Switching Power Supply   DC to DC Converter   Inverter
Battery charger   Led flasher   Motor speed controller   LM317   IC 741
RF radiofrequency   Electronic control   Digital Circuit   Alarm home system
DC to DC converter step up voltage   Mini project   Temperature control
FM receiver   Dual power supply   Fluorescent lamp   Pic microcontroller
Led display   RF amplifier   FM transmitter   LM324   LM723   TL494
2N3055   LM338   SG3525   Li-ion battery charger   Pulse generator