Infrared Remote Control

This circuit will allow you to turn on any piece of equipment that operates on 115 volts ac. The receiver circuit is based on the Radio Shack infrared receiver module (MOD), part number 276-137. It is also available from some of the other sources listed on my Links page. The MOD accepts a 40khz IR signal that is modulated at 4 khz. When a signal is received the MOD will go low. The sensitivity of the MOD is set by different values for R1 and C1. The values for R1 may need to be as high as 10,000 ohms and for C1 40uf. This will prevent the unit from turning on under normal lighting conditions. You will need to experiment with the values that work best for you. The output of the 4013 chip a flip flop toggles on and off with the reception of a IR pulse. The output of the 4013 turns on the MOC optical coupler which in turn switches on the triac and supplies power to the AC load.

From :: http://home.maine.rr.com/randylinscott/aug98.htm

Power Supply   Switching Power Supply   DC to DC Converter   Inverter
Battery charger   Led flasher   Motor speed controller   LM317   IC 741
RF radiofrequency   Electronic control   Digital Circuit   Alarm home system
DC to DC converter step up voltage   Mini project   Temperature control
FM receiver   Dual power supply   Fluorescent lamp   Pic microcontroller
Led display   RF amplifier   FM transmitter   LM324   LM723   TL494
2N3055   LM338   SG3525   Li-ion battery charger   Pulse generator