Circuit Project Electronic

Circuit : Andy Collinson
Email: anc@mitedu.freeserve.co.uk

Description:
A low noise pre-amplifier suitable for amplifying dynamic microphones with 200 to 600 ohm output impedance.

Notes:
This is a 3 stage discrete amplifier with gain control. Alternative transistors such as BC109C, BC548, BC549, BC549C may be used with little change in performance. The first stage built around Q1 operates in common base configuration. This is unusuable in audio stages, but in this case, it allows Q1 to operate at low noise levels and improves overall signal to noise ratio. Q2 and Q3 form a direct coupled amplifier, similar to my earlier mic preamp.

Related Links
More circuit microphone preamplifier
More Circuit Pre Mic
Microphone Preamplifier by IC TL084
Pre MIC (microphone preamplifier) 3 CH by IC LM348
Two Microphone Preamplifier by BC109
Dynamic Microphone Preamp Mono by Transister C945 (with PCB)
Dynamic Microphone Preamp
Power Amplifier OCL 100W Mosfet J162 + K1058
Power Amp OCL 100W by Transister MJ15003,MJ15004(with PCB)
Amp OTL 100W by 2N3055 (with PCB)
TDA2004 Amplifier Car audio stereo OTL 10W+10W (with PCB)
TDA2005 Amplifier Car audio BCL 20W (with PCB)
More circuit Tone control - Graphic Equaliser
Active Tone Controls by Transistor
Tone Control Mono by Transister C945×5
Pre Tone Control Stereo (bass-mid range-treble) by IC NE5532
10 Channels Graphic Equaliser by LA3600
More circuit about OCL Amplifier HIFI
More circuit about BCL Amplifier HIFI