Circuit Project Electronic

How do we achive 10nA operation? By using diodes in place of pull up resistors, and by isolating the DC load from the trigger circuit via junction drops and the 10nF capacitor. If there is too much power comming from the solar cell then the motor might run too often or even continuously. You can avoid this by putting a 100K ohm resistor in series with the solar cell.

Read more original source:
http://members.shaw.ca/novotill/SolarPoweredMotor/index.htm

This entry was posted on Wednesday, July 2nd, 2008 at 1:38 pm and is filed under Electronic Control, Lighting. You can follow any responses to this entry through the RSS 2.0 feed.