Control stepping motor via USB interface

This is an example that demonstration how to control some devices via USB interface.The PC software program with delphi. Feature: - CPU PIC18F4550 with full speed USB interface at 48MHz. - USB 2.0 compliance - Use on-chip USB driver - Control 1 stepping motor. - MPLAB C18 for firmware at USB devices side. - Delphi 6 for PC Host software. USB devices side Figure 1. is the schematic for this example.PIC18F4550 is the main devices that communicate with PC and control stepping motor. The power supply came from +5V Vbus for circuit except +Vmotor which must use external power supply that depend on stepping motor requires. If you add more components into circuit that drawn total current more than 250mA you should be use +5V external power supply instead Vbus.Becuase Vbus can supplies current not more than 250mA and don’t forgot to disconnect Vbus out of circuit.

Read More Source:
http://www.sixca.com/eng/articles/usbstepping/index.html
Thank you.

Power Supply   Switching Power Supply   DC to DC Converter   Inverter
Battery charger   Led flasher   Motor speed controller   LM317   IC 741
RF radiofrequency   Electronic control   Digital Circuit   Alarm home system
DC to DC converter step up voltage   Mini project   Temperature control
FM receiver   Dual power supply   Fluorescent lamp   Pic microcontroller
Led display   RF amplifier   FM transmitter   LM324   LM723   TL494
2N3055   LM338   SG3525   Li-ion battery charger   Pulse generator