Circuit Project Electronic

This is circuit power amplifier for car. use IC TDA7384.
Output power 34Wx4 at speaker 4OHM.
read intro detail:

So this time I decided to make pretty simple but powerful enough audio amplifier. For this I’ve chosen quad bridge car audio amplifier TDA7384 which has four input and four output channels with power capability 4×35W.

If connect to car battery where operating voltage is about 13.2V, then each channel can give 22W(4Ω) – what is more than enough for me. This amplifier I probably will use to test audio processor TDA7313 which is stil in development phase. I didn’t find much information about this chip on the internet so I decided to built it and try on my own.

As datasheets of TDA7384 says it is low distortion, low output noise, low external component count. Also has Stand-By function and Mute function. It has several protections like from output short circuit to GND or to Vs, capable to handle very inductive loads, thermal limiter, load dump voltage. TDA7384 is an AB power amplifier cased in flexiwatt25 (eagle library is included in project archive) package wich is designed for high end car radio applications. It allows rail to rail output voltage swing with no need of boot-strap capacitors.

Related Links
More Circuit car power amplifier
More circuit Power Amp MOSFET
More circuit Power Amplifier
SG3525 DC Converter 12V to +35V,-35V
dc converter 12V to +30V - 30V for car with IC SG3525
12V to +-20V converter for audio amplifier
50W Power Amplifier OCL Mosfet (K1058 + J162)
40W Amp OCL 2N3055+MJ2955
Power Amplifier OCL 100W Mosfet J162 + K1058
Power Amp OCL 100W by Transister MJ15003,MJ15004(with PCB)
Power Amplifier Mono BCL 20W by IC TDA2005
TDA2003 Amplifier BCL (low cost) 18W for CAR (with PCB)
TDA2005 Amplifier Car audio BCL 20W (with PCB)
TDA1908 Amplifier CAR AUDIO OTL 8W
HA1377 Bridge Amplifier BCL cap 17W (with PCB)

Read More Source:
http://www.scienceprog.com/diy-4×22w-car-audio-amplifier-based-on-tda7384
Thank you.