300 MHz Prescaler by MCT10280

Advertisements

A preamp that drives the CMOS counter input and a divide by 10 prescaler to extend the range of A Little More Serious Frequency Meter. The MCT10280 prescaler can be set to divide by 80, 40, 20, or 10, as a function of which pins are tied to the power supply. I set this one to divide by 10 since it is adequate for my needs, and the mental calculation of multiplying the meter reading by 10 is not taxing. One problem with the MCT10280 is that if it doesn’t have an adequate input, the output is very noisy, which shows up as counts in the couple MHz range on the frequency meter. This noise shows up if the signal amplitude the signal frequency is too low. For this reason, I only intend to use the prescaler with inputs between 10 MHz and 300 MHz.

Read More Source:
http://cappels.org/dproj/preamprescaler/preampresc.html
Thank you.

This entry was posted on Saturday, December 29th, 2007 at 1:21 am and is filed under Pre Amplifier - microphone preamp, RF-Radio Frequency. You can follow any responses to this entry through the RSS 2.0 feed.