Circuit Project Electronic

It uses a normal 120 to 6V stepdown transformer in reverse to step 12V to about 350V to drive a lamp without the need to warm the filaments.

Q1 must be installed on a heat sink. A 240V to 10V transformer will work better then the one in the parts list. The problem is that they are hard to find. This circuit can give a nasty (but not too dangerous) shock. Be careful around the output leads.

Related Links
12 Volt Fluorescent Lamp 20W Drivers
More circuit Fluorescent Lamp
More circuit Lighting
More circuit Automotive
More circuit about Inverter circuit
Inverter 100W by IC 4047 + 2N3055 (with PCB)
Inverter 12V to 220V 300W by NE555,2N3055
DC24V to AC220V Inverter 300W by NE555,CA3130,MJ15003
Inverter 100W by IC 4047 + 2N3055 (with PCB)
12 Volt to 220 Volt Inverter 500W
Inverter 100W 12V to 220V by Transistor

Read More Source :
http://www.aaroncake.net/circuits/flampdrv.asp
Thank you.

This entry was posted on Sunday, August 26th, 2007 at 2:22 pm and is filed under Lighting, inverter. You can follow any responses to this entry through the RSS 2.0 feed.