110VAC Inverter for Automobile by 4013, 555, 4020, and 4049

The design depends on the windings ratio and the value of the car battery to produce an AC waveform of approximately 95 volts RMS. No filtering is performed on the secondary since the transformer blocks most of the sharp edges from the input waveform.

All of the devices (4013, 555, 4020, and 4049) should have their supply pins connected to the +12 supply. The nice thing about CMOS logic is that it will operate over a wide range of voltages. Before connecting the center tap of the transformer, adjust R3 until the signal on U5 pin 13 is 120Hz.

The 4013’s are used to produce a 60Hz square wave with an accurate 50% duty cycle and to force the FET switches operate in a break-before-mate manner. The 4049’s have enough drive capability to snap the FET’s off and on very quickly.

Read More Source:
http://web-ee.com/schematics/power_conversion/
12-volt-automobile-inverter/
Thank you.

This entry was posted on Sunday, January 27th, 2008 at 7:23 am and is filed under Automotive, inverter. You can follow any responses to this entry through the RSS 2.0 feed.