Subscribe to RSS Feed

Dry cell battery charger

April 28, 2012 by

Dry cell battery charger

Easy dry cell charger with CMOS IC 4011 The dry cell charger circuit can be fully charged about 12 hours.When used with a 9 volt supply,the equipments in the circuit for the AA type cell.When using the C and D type cell, should reduce the value of the resistance Rx to be 68 ohms.In charge of the cell, you should not be charged [...]

Dry Cell Battery Charger using LM741 and IC4011 This is Dry Cell Battery Charger Circuit. That can use charger battery get that about 12 hour. When apply to power supply 9 volt the equipment that fix in the circuit use for size battery AA. If use the size C or D should devalue of Resistor RX down be 68ohm and should not lead [...]


Salt Water Battery About 13 years ago, I made a salt water battery to operate a single AA battery quartz clock. It ran for several months until I got tired of adding water to compensate for evaporation. The batttery consisted of 5 cells each producing about 300 millivolts. As I remember, I used 5 small olive jars filled [...]

Tags:

This entry was posted on April 28, 2012 at 10:21 am and is filed under battery. You can follow any responses to this entry through the RSS 2.0 feed.

Comments are closed.

RSS Electronic projects circuits

  • Fuse status indicators for 12 volts power supply May 21, 2013
    This circuit is a Fuse status indicators for power supply 12V. If a fuse is normally, the LED is going to lights all the time. But when it lacks, the LED will be blinking. The value of this equipment in the circuit is suitable for a 12 volt power supply. However able to change the power supply 6 volt or 24 volt, By reducing the value of the resistor to half […]
    admin
  • Logic probe tester circuit May 17, 2013
    They are digital logic probe circuits that you make easliy. Most digital circuits that used CMOS ICs. because I like using CMOS ICs. Because it needs a voltage of approximately 3V to 12V and the power consumption is low. If we use the battery power for longer than IC-TTL. But when problems need to Logic. We use a CMOS IC is suitable or more efficient. And in […]
    admin
  • Random Number Generator by IC 4017 and 4011 May 16, 2013
    This be Random Number Generator Circuit there is the character is 10 LED Flasher by use IC 4017 and IC 4011 integrated circuit. For the 4017 IC is a 16-pin CMOS decade counter. It takes clock pulses from the clock input, and makes one of the ten outputs come on in sequence each time a clock pulse arrives. Usability press S1 forLED Flasherrespectively. By pre […]
    admin
  • LED Chaser by IC 4017 + IC 555 May 16, 2013
    I believes in that extremely amateur electronics many you, may ever build the LED flasher or light blinks or the LED Chaser prevent come to already. Today I begs for to advise the circuit LED Chaser, by have LED show 10 amounts together. blink stick bright chase go to continually. By have IC CD4017 circuits precede at drive a tube LED all. Which its work be […]
    admin
  • 10 LED Flashing using CD4017 May 16, 2013
    This the circuit light led flashing with show of 10 LED. By use integrated number circuit CD4017 perform be Decade Counter/Divider with 10 Decoded Outputs. Which it is integrated digital circuit CMOS then use the power supply about 9VDC. For a signal input continue the circuit can produce general frequency may use IC NE555 all right. […]
    admin