Subscribe to RSS Feed

Airflow sensitive circuit

April 8, 2012 by

Car Exhaust Meter
Bridge circuit contains two resistors lOO-ohm (R3 and R4), and two thermistors (Tl and T2). At room temperature, the resistance of T1 and 1’2 is about 2000 ohms. When they are each heated to 150 °C by an RNA 10 current, the resistance value decreases to 100 ohms. So. the four elements include a bridge [...]
Air Flow Detector
This simple circuit uses an incandescent lamp to detect airflow. With the filament exposed to air, a constant current source is used to slightly heat the filament. As it is heated, the resistance increases. As air flows over the filament it cools down, thus lowering it’s resistance. A comparator is used to detect this difference [...]
Self-heated transistor digitizes airflow
A sensitive and reliable way to measure airflow is to exploit the predictable relationship between airspeed and the heat dissipated by a sensor exposed to the flow while being held at a constant temperature differential above ambient. The power required to maintain the elevated sensor temperature is proportional to the square root of the airspeed [...]
Read more Airflow sensitive circuit

Tags:

This entry was posted on April 8, 2012 at 2:54 pm and is filed under detector. You can follow any responses to this entry through the RSS 2.0 feed.

Comments are closed.

RSS Electronic projects circuits

  • Smoke detector circuit May 22, 2013
    A smoke detector is part of a sophisticated alarm system. Which within the system is a professional, most will include Section detector gas, room filling ions. Or sensitive to radio signals. However, this circuit does not have to be so complicated. Just another 2 LDRs and LED detection. Only the number of IC LM1801, the circuit helps the device is much less. […]
    admin
  • Fuse status indicators for 12 volts power supply May 21, 2013
    This circuit is a Fuse status indicators for power supply 12V. If a fuse is normally, the LED is going to lights all the time. But when it lacks, the LED will be blinking. The value of this equipment in the circuit is suitable for a 12 volt power supply. However able to change the power supply 6 volt or 24 volt, By reducing the value of the resistor to half […]
    admin
  • Logic probe tester circuit May 17, 2013
    They are digital logic probe circuits that you make easliy. Most digital circuits that used CMOS ICs. because I like using CMOS ICs. Because it needs a voltage of approximately 3V to 12V and the power consumption is low. If we use the battery power for longer than IC-TTL. But when problems need to Logic. We use a CMOS IC is suitable or more efficient. And in […]
    admin
  • Random Number Generator by IC 4017 and 4011 May 16, 2013
    This be Random Number Generator Circuit there is the character is 10 LED Flasher by use IC 4017 and IC 4011 integrated circuit. For the 4017 IC is a 16-pin CMOS decade counter. It takes clock pulses from the clock input, and makes one of the ten outputs come on in sequence each time a clock pulse arrives. Usability press S1 forLED Flasherrespectively. By pre […]
    admin
  • LED Chaser by IC 4017 + IC 555 May 16, 2013
    I believes in that extremely amateur electronics many you, may ever build the LED flasher or light blinks or the LED Chaser prevent come to already. Today I begs for to advise the circuit LED Chaser, by have LED show 10 amounts together. blink stick bright chase go to continually. By have IC CD4017 circuits precede at drive a tube LED all. Which its work be […]
    admin