Subscribe to RSS Feed

This is the Power Switching Regulator 9V Circuit that is low current power output and It has strong point is the voltage input change from 2.4V to 10V but a constant voltage output 9 Volt. We used the RC4193 Micropower Switching Regulator is the base, easy to use and there are a few parts in circuit. The test battery point for check voltage of batter or input.
The low power switching regulator IC, number: RC4193, that that Contained in a small body of caterpillar 8-pin. It is designed for devices that work with batteries. The DC regulator power supply is built by the 11 normal parts. By has the 5 resistors, 2 capacitors, a diode, a choke coil and IC no.RC4193 and that importance the battery 2.4 volt to 9 volt : 1 set.
How it works
-This power supply has stable output voltage at 9V until battery is worn down to less than 2.4V The circuits is actual as shown below.
-The RC4193 has a reference circuit inside, is controlled by the Ic current and is define from the resistor R1 that connected externally to IC1
Read more

Tags:

Comments are closed.

RSS Electronic projects circuits

  • How to make simple electronic buzzer April 21, 2014
    A electronic buzzer is simple. But useful well worth and the price is lower than 1$. By use just a 9-volts battery only. So without worrying about electrical leakage or electric shock from 220V to buzzer. Unless also has LED will glow. Show that the circuit the normal operation as well. The working of circuit. […] […]
    admin
  • Automatic night light switch using 741 op-amp. April 21, 2014
    We’ve watched a lot of Automatic night light switch circuits. Which I like to use a transistor as base. But now we lets to see IC-op-amp. It is also very simple. As my feelings It has high sensitivity more than one, and with great high accuracy. How does it works. A light detector component, we […] […]
    admin
  • Simple Two digits counter using CD4026 April 19, 2014
    This is a simple two digit counter using CD4026 as main parts can display with LED 7 segment 0-99 number There is a reset button to restart. It can be applied to, for example, counting products, counting people into the library, and more. The working principle As circuit in Figure 1. The IC1, IC2-CD4026 4026 […] […]
    admin
  • Morning alarm with sunlight using IC-4011 April 17, 2014
    This is simple circuit that we makes in hobby time or toys for my son but really uses. It will have sound alarm when morning like a normal clock alarm with lighting sensor same clock. We use a IC-4011 CMOS only one and a few components also can generate pulsating tone like a general clock. […] […]
    admin
  • Simple Electronic clock sound using IC4011 April 17, 2014
    The sound of insects such as crickets, cicadas, resulting from flutter briefly. We can use a multivibrator to connects as sound generator circuit to imitate these insects sound. Some electronic clock alarm tone also sounds similar to these insects. As Figure 1 is simple clock alarm sound generator that can assemble on a breadboard right […] […]
    admin