Subscribe to RSS Feed

Archive for November, 2011

Pushmatic circuit breakers

November 22, 2011 by

This 120-Volt ITE pushmatic 20 amp, single pole replacement circuit breaker is used in a pushmatic load center. Typical applications, up to 2,200-Watt, include kitchen circuits, branch circuits, wall receptacles, electric heaters (up to 1,650-Watt), dishwashers, refrigerators, freezers, washing machines, window air conditioners (110-Volt, up to 5,500 BTU) and electric motors (3/4-to-1-1/4-Horsepower). These are only suggested applications and cannot assure compliance with all local codes. Please check local electrical codes before starting any electrical project….
More about Pushmatic circuit breakers

Continue Reading »
No Comments

Super Switch Wireless Remote

November 22, 2011 by

Wireless remote control wall outlet plugs into any standard household outlet and conveniently turns on – and off – lamps, small appliances, holiday lights and more. Unit includes single button remote, NOT three button as shown. Single button remote operates up to a 60-ft. range, even through doors, floors and walls. 10Amp draw. 12 Volt battery included. Read more information

Continue Reading »
No Comments

RSS Electronic projects circuits

  • Smoke detector circuit May 22, 2013
    A smoke detector is part of a sophisticated alarm system. Which within the system is a professional, most will include Section detector gas, room filling ions. Or sensitive to radio signals. However, this circuit does not have to be so complicated. Just another 2 LDRs and LED detection. Only the number of IC LM1801, the circuit helps the device is much less. […]
    admin
  • Fuse status indicators for 12 volts power supply May 21, 2013
    This circuit is a Fuse status indicators for power supply 12V. If a fuse is normally, the LED is going to lights all the time. But when it lacks, the LED will be blinking. The value of this equipment in the circuit is suitable for a 12 volt power supply. However able to change the power supply 6 volt or 24 volt, By reducing the value of the resistor to half […]
    admin
  • Logic probe tester circuit May 17, 2013
    They are digital logic probe circuits that you make easliy. Most digital circuits that used CMOS ICs. because I like using CMOS ICs. Because it needs a voltage of approximately 3V to 12V and the power consumption is low. If we use the battery power for longer than IC-TTL. But when problems need to Logic. We use a CMOS IC is suitable or more efficient. And in […]
    admin
  • Random Number Generator by IC 4017 and 4011 May 16, 2013
    This be Random Number Generator Circuit there is the character is 10 LED Flasher by use IC 4017 and IC 4011 integrated circuit. For the 4017 IC is a 16-pin CMOS decade counter. It takes clock pulses from the clock input, and makes one of the ten outputs come on in sequence each time a clock pulse arrives. Usability press S1 forLED Flasherrespectively. By pre […]
    admin
  • LED Chaser by IC 4017 + IC 555 May 16, 2013
    I believes in that extremely amateur electronics many you, may ever build the LED flasher or light blinks or the LED Chaser prevent come to already. Today I begs for to advise the circuit LED Chaser, by have LED show 10 amounts together. blink stick bright chase go to continually. By have IC CD4017 circuits precede at drive a tube LED all. Which its work be […]
    admin